Although the electric water heater is installed on the space requirements of gas-fired water heater has not so strict, but also the safe use, choose to take into account
1 installed first by sea and then loaded circuit. The installation of water. Using special screws will be linked to fixed on the wall, put up water heater, and then mixing valves are installed on the water pipe valves, mixing valves and water heaters used in and out between the pipes, nuts, connecting ring.
2 cleaning system. After the installation of water, you have to clean the entire system, and then installed circuit. Specific methods are: cold water valve clearance, the hot water valve, open the water valve to let water into the tank, mixing valves are flowing out, they can increase the flow of water tanks for irrigation pipes, water valves opened, the body wash Internal access road, and then connect to the showers.
3 circuits installed. 1 meter away from the water heater is far higher than 1.5 meters above the ground where the power switch installed. Open the water heater case, then a good power cord, according to the attention of the power to choose the appropriate size of the power cord, and then a good ground.
Before use to fill water and then electricity, heating pipe to prevent dry and lead to leakage. Must take a good and reliable ground, in the absence of a good grounding device should be cut off after the warm-up before the use of power. And in the private leased circuits on the current configuration of the appropriate size of the fuse block to prevent the lines are too small and bad, leading to leakage and fire.